[AIOT] COM Setting for PV100A

ASUS Support FAQ

FAQ

Product PV100A

1. Boot up PV100A

2. Open terminal

3. Using command “PV100A-config” into the setting, shows below:

4. Select “OK”

5. Select “6 UART” to change protocol (RS232/ RS485)

6. Select RS232 or RS485

7. Press “OK”

8. Press ‘Tab’ to select “Finish”

Yes No

Contact Support

Please contact with us if the above information cannot resolve your problem

Above information might be partly or entirely quoted from exterior websites or sources. please refer to the information based on the source that we noted. Please directly contact or inquire the sources if there is any further question and note that ASUS is neither relevant nor responsible for its content/service
This information may not suitable for all the products from the same category/series. Some of the screen shots and operations could be different from the software versions.
ASUS provides the above information for reference only. If you have any questions about the content, please contact the above product vendor directly. Please note that ASUS is not responsible for the content or service provided by the above product vendor.
Brand and product names mentioned are trademarks of their respective companies.

ASUS Support FAQ