[AIOT] How to Get the Console Log for Tinker Board 3N

ASUS Support FAQ

FAQ

Product Tinker Board 3N

Hardware:

Using a cable (pitch 2.0mm (female) to pitch 2.54mm (male)) and a USB serial cable to connect Tinker Board 3N and PC.

a. Connect TXD pin on the converter to RX pin on the Debug UART.

b. Connect RXD pin on the converter to TX pin on the Debug UART.

c. Connect GND pin on the converter to GND pin on the Debug UART.

On PC, open Putty and select Serial.

The Serial line can be checked from Windows >Device Manager >Ports (COM & LPT). The speed is 1500000 baud.

Click the Open button on Putty and power the board, and some boot logs will be printed on Putty from PC:

Yes No

Contact Support

Please contact with us if the above information cannot resolve your problem

Above information might be partly or entirely quoted from exterior websites or sources. please refer to the information based on the source that we noted. Please directly contact or inquire the sources if there is any further question and note that ASUS is neither relevant nor responsible for its content/service
This information may not suitable for all the products from the same category/series. Some of the screen shots and operations could be different from the software versions.
ASUS provides the above information for reference only. If you have any questions about the content, please contact the above product vendor directly. Please note that ASUS is not responsible for the content or service provided by the above product vendor.
Brand and product names mentioned are trademarks of their respective companies.

ASUS Support FAQ